Stoner Crafts: DIY Weed iPhone Case

Your cell phone case is a reflection of who you are.. or who you tell the world you are

My iPhone case wasn’t "stoner" enough so I created this marijuana covered case

Now I'm going to show you how I did it so you can replicate my craft and have your own weed iphone case.

You will need:

• A High Times Magazine 

• Phone case with a clear back

• Pen

• Scissors

• Exacto Knife

Step One - TEMPLATE

A lot of cell phones come with a fake paper cell phone inside the case, so if yours has one then that makes the craft a whole lot easier.

**If not you can just trace the silhouette of the phone and subtract a few millimetres so it fits inside the case

Step Two - SELECTING YOUR IMAGE & TRACE

Place your phone case over the an area of the magazine that you like. Make sure the image is big enough to fill up the entire back of the phone.

Then remove the phone and place your template over the same area that your phone case just was.

Trace around your template with your pen

Step Three- CHOP CHOP and CHECK

Cut along your lines with your scissors and TA DA, you have a piece of paper the size of the back of your phone.

Check to make sure it fits in your phone nicely, keep making adjustments until it fits. 

Step Four- CAMERA HOLE and CHECK

Now we need to cut a hole in the paper for the camera.

With your paper inside your phone case trace inside the camera hole.

Then carefully pull out the piece of paper from the case and cut along the lines (or circle) you just drew with your exact knife.

Take it nice and slow, you don’t want to screw this up when we are soo close to being done.

Once you’re done the cutting, put the piece of paper back in the case to check. Cut away the extra paper as needed.

Step Five- CASE IT UP

Once you have a perfectly sized paper place your phone back in the case over the piece of paper. 

And know you have a beautiful cannabis cell phone case

that isn't just pot leaves, enjoy!